IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 215 / 257

Appendix D. Sense Data
D-5
12–13 Additional Sense Code (ASC)
Additional Sense Code Qualifier (ASCQ)
Byte 12 Byte 13
ASC ASCQ
3F 01 Code Download - The firmware in the drive has just been changed by a Write Buffer
command.
40 xx Diagnostic failure - A diagnostic test has failed. The xx (ASCQ) is a vendor specific code
indicating the failing component.
43 00 Message Error - A message could not be sent or received due to excessive transmission
errors.
44 00 Internal target failure - A hardware failure has been detected in the drive that has caused
the command to fail.
45 00 Select/Reset Failure - An attempt to reselect an initiator in order to complete the
command has failed.
4B 00 Data Phase Error - A command could not be completed because too many parity errors
occurred during the Data phase.
4E 00 Overlapped Commands - An initiator selected the drive even though it already had a
command outstanding in the drive.
50 00 Write Append Error - A write type command failed because the point at which to
append data was unreadable.
51 00 Erase failure - An Erase command failed to erase the required area on the media.
52 00 Cartridge fault - A command could not be completed due to a fault in the tape cartridge.
53 00 Media Load/Eject Failed - (Sense Key 03) An attempt to load or eject the cartridge failed
due to a problem with the cartridge.
53 00 Media Load/Eject Failed - (Sense Key 04) An attempt to load or eject the cartridge failed
due to a problem with the drive.
53 02 Media Removal Prevented - An Unload command has failed to eject the cartridge
because media removal has been prevented.
5D 00 Failure Prediction Threshold - Failure Prediction thresholds have been exceeded
indicating that a failure may occur soon.
5D FF Failure Prediction False - A Mode Select command has been used to test for Failure
Prediction system.
82 82 Drive requires cleaning - The drive has detected that a cleaning operation is required to
maintain good operation.
82 83 Bad Code Detected - The data transferred to the drive during a firmware upgrade is
corrupt or incompatible with drive hardware.
Sense Key 0 (No Sense)
EE 13 Encryption - Key Translate
EF 13 Encryption - Key Translate EKM
Sense Key 3 (Medium Error)
30 02 Encryption - Encryption feature is not enabled so format/processing is not supported.
EE 60 Encryption - Proxy Command Error
EE D0 Encryption - Data Read Decryption Failure
EE D1 Encryption - Data Read after Write Decryption Failure
EE E0 Encryption - Key Translation Failure
EE E1 Encryption - Key Translation Ambiguous
EE F0 Encryption - Decryption Fenced (Read)
EE F1 Encryption - Encryption Fenced (Write)
Sense Key 4 (Hardware Error)
EE 0E Encryption - Key Service Timeout
EE 0F Encryption - Key Service Failure
40 00 Encryption - Failure Hardware, POST or Module Failure
Table D-3. Ultrium Tape drive sense data (continued)
Byte
Bit Address or Name
7 6 5 4 3 2 1 0