IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 46 / 257

3-2
TS2900 Tape Autoloader Setup, Operator, and Service Guide
The following additional items are required for installation and library operation:
• SAS cable
• Data cartridges
• Cleaning cartridge
• Ethernet cable
Important: If any of the contents of your shipment are damaged or missing, please
call the appropriate number listed on the Quality Hotline card.
Choosing a Location
Choose a location that meets the following criteria:
Installing the Deskside Cover
A deskside cover and six feet must be installed on the library chassis before the
library can be used as a desktop unit. If you intend to install the library in a rack, skip
this step and proceed to “Installing in a Rack” on page 3-5.
Table 3-2 lists the parts in the deskside assembly kit. A Phillips head screwdriver
(preferably with a magnetic head) will be needed to assemble the deskside kit.
Table 3-1. Location criteria
Criteria Definition
Room temperature 16 to 32 °C (60 to 90 °F)
Voltage 100 to 240 Vac. (4.0 to 1.5 A)
Note that the power switch is located on the rear of the library and
must be easily accessible at all times.
Frequency 50 to 60 Hz
Relative humidity 20 to 80% non-condensing
Air quality The library should be placed in an area with minimal sources of
particulate contamination. Avoid areas near frequently used doors and
walkways, stacks of supplies that collect dust, printers, and
smoke-filled rooms. Excessive dust and debris can damage cartridges
and the tape drive.
Clearance • Back: Minimum of 15 cm (6 in.)
• Front: Minimum of 30 cm (12 in.)
• Sides: Minimum of 5 cm (2 in.)
Rack requirements Standard EIA 19-inch rack: 1U space
Table 3-2. Deskside kit
Number Part Number Quantity Description Part
45E3240 6 1U desktop foot
1
a29z0034