IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 180 / 257

A-10
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Removing/reinstalling the Tape Drive from/in the Library
To remove the SAS tape drive from the library, complete the following steps:
1. Turn OFF the power to the library.
2. Disconnect all cables from the rear panel of the library.
3. Remove the library cover(s). See “Removing/reinstalling the Library Chassis
Cover” on page A-5.
4. Disconnect the internal SAS cable ( in Figure A-12).
Figure A-12. Rear panel of the SAS Half-high drive
5. If connected, disconnect the internal LDI (RS-422) cable from the LDI (RS-422)
connector ( in Figure A-12).
6. Remove the cartridge magazine from the library.
7. Remove the drive mounting screws from the sides of the tape drive housing. Two
screws are located on each side of the drive (Figure A-13).
Figure A-13. Drive housing screw locations
8. Lift the tape drive out of the library chassis (Figure A-14).
2
a80hh024
1 3 2
4
3
a29z0062