IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 84 / 257

4-6
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Select Execute to move the cleaning cartridge to the drive and start drive head
cleaning. The cleaning cartridge is returned to its home position when cleaning is
finished.
Conducting a Library Inventory
Figure 4-11. Inventory command
Use Commands
→
Inventory to force the library to execute an inventory of the
cartridge magazine, accessor, and tape drive to refresh the library map. An inventory
is conducted automatically when power is turned ON and when the cartridge
magazine is inserted.
Select Execute to conduct the inventory.
Taking the Library Online/Offline
Figure 4-12. Online/Offline command
Use Commands
→
Change Library State to take the library online or offline.
It is sometimes necessary to take the library offline before performing some servicing
functions for the library. Once these operations have finished, it is necessary to bring
the library back online.
Note: The tape drive is always online, even when the library is offline.
Powering Down the Library
Before powering OFF the library, make sure that the library is in an idle state with no
mechanical movement of the Accessor, and all data operations (e.g. backup
operations, accessing of log files, etc.) have completed. Then, power OFF the library
using the power switch on the rear panel of the library.
Important: If you switch the library power OFF while the library is being accessed,
loss of data may occur.
Note: When power cycling the library, wait 10 seconds after the power is OFF before
powering ON again.
Preparing to Ship the Library
Figure 4-13. Move to Ship Position command
Use Commands
→
Move to Ship Position when preparing to move the library to a
new location. The Accessor must be placed in a parked position within the library
Commands
Inventory
Commands
Change Library State
Set Library Online
Set Library Offline
Commands
Move to Ship Position