IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 66 / 292

1 - 10-32 screws with square-cone washers (6)
Note: For rails with round holes, use the clip nuts on the rack rails for securing 10-32 screws. For
rails with square holes, use the retainer nuts (refer to Figure 1). Also refer to Figure 3.
7. Reinstall the door. Refer to procedures for removing and replacing the device door in this guide.
Installing the 8U Chassis 27-31-Inch Rail Rack Kit for Four-Post Racks
Use the following instructions to install the device in a rack using the 8U Chassis 27-31 Inch Rail Rack Kit
for Four-Post Racks . Any updates to these instructions will be added to the hardware installation guide
for your product.
Note: Hardware devices illustrated in these procedures are only for reference and may not depict the
device you are installing into the rack.
Time and items required
Allow approximately one hour to unpack and install a device in a rack.
The following tools are required to install the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post Racks.
v
Torque wrench with #2 Phillips screwdriver tip
v Flathead screwdriver
v Hydraulic or assisted lift with a minimum raise of 140 cm (55 in.) and a minimum capacity of 113 kg
(250 lbs).
Figure 21. Device installed in mid-mount saddle
38
SAN256B-6 Installation, Service, and User Guide