IBM SAN256B-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 49 / 292

Torque requirements
Use the following torque settings when tightening screws that secure the rack mount kit and device to
the rack.
Table 9. Torque requirements for mounting screws
Screw size Torque
6-32 x .25 in. (.635 cm) Phillips screw 8.75 in-lb (10 cm-kg)
10-32 x .63 in.(1.60 cm) Phillips screw 32 in-lb (36.86 cm-kg)
Assembling the rack hardware
Procedure
1. Determine how the device can be oriented in the rack so that the non-port side has access to intake
air (cool).
2. Install clip nuts (8 in Figure 7) or retainer nuts (9 in Figure 7) in rack rail locations shown in the
following figure. These nuts will secure the 10-32 screws that mount the rack kit's shelf and the device
to the rack. For rails with round holes, use clip nuts. For rails with square holes, use retainer nuts.
Note that the following figure shows relative positions for these nuts in the rack rails to mount the
shelf and device. You may mount the shelf and device in 9U of rack space higher or lower in the rack
than shown.
1 - Attaching clip nuts for round hole rails
2 - Clip or retainer nut locations for device
3 - Clip or retainer nut locations for shelf
4 - Retainer nut for rails with square hole
5 - Rail
Figure 4. Clip and retainer nut locations on rack rails
Mounting the Device
21