IBM Netfinity 5100 8658 21Y, Руководство пользователя

Страница: 88 / 246

4. Remove the defective hard disk drive: move the handle
on the drive to the open position (perpendicular to the
drive) and pull the hot-swap tray from the bay.
5. Remove the four screws that attach the drive to the
hot-swap tray, and remove the drive from the tray.
6. Place the new hard disk drive on the hot-swap tray
and, being careful not to over-tighten the screws ,
attach the drive to the tray using four screws.
7. Install the hard disk drive in the hot-swap bay:
a. Ensure the tray handle is open (that is,
perpendicular to the drive).
b. Align the rails on the drive/tray assembly with the
guide rails in the drive bay.
c. Gently push the drive/tray assembly into the bay
until the drive connects to the backplane.
d. Push the tray handle toward the closed position
until it locks the drive in place.
8. Check the hard disk drive status indicators to verify
that the hard disk drive is installed properly (see
“Server controls and indicators” on page 8 for the
location of the status indicators).
v When the amber light is on continuously, the drive
has failed.
v When the amber light flashes slowly (one flash per
second), the drive is being rebuilt.
v
When the amber light flashes rapidly (three flashes
per second), the controller is identifying the drive.
v If you have a RAID adapter installed, when the
green Activity light is on continuously the drive is
ready
9. If your server is a tower model, close and lock the
server door.
Installing a non-hot-swap drive
Note: The server’s EMI integrity and cooling are both
protected by having the non-hot-swap bays covered
or occupied. When you install a drive, save the filler
panel from the bay, in case you later remove the
78
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY