IBM Netfinity 5100 8658 21Y, Руководство пользователя

Страница: 35 / 246

sure that the hub and network are operating and that
the correct device drivers are loaded.
– The Ethernet Speed 100 Mbps light illuminates when
the Ethernet controller LAN speed is 100 Mbps.
v Make sure that you are using the correct device drivers,
supplied with your server.
v Check for operating system-specific causes for the
problem.
v
Make sure that the device drivers on the client and
server are using the same protocol.
v Test the Ethernet controller.
How you test the Ethernet controller depends on which
operating system you are using (see the Ethernet
controller device driver README file).
Ethernet controller troubleshooting
chart
You can use the following troubleshooting chart to find
solutions to 10/100 Mbps Ethernet controller problems that
have definite symptoms.
Table 1. Ethernet troubleshooting chart
Ethernet
controller
problem Suggested Action
The server
stops running
when loading
device drivers. The PCI BIOS interrupt settings are incorrect.
Check the following:
v
Determine if the interrupt (IRQ) setting
assigned to the Ethernet controller is also
assigned to another device in the
Configuration/Setup Utility program.
Although interrupt sharing is allowed for PCI
devices, some devices do not function well
when they share an interrupt with a
dissimilar PCI device. Try changing the IRQ
assigned to the Ethernet controller or the
other device. For example, for NetWare
Versions 3 and 4 it is recommended that
disk controllers not share interrupts with LAN
controllers.
v Make sure that you are using the most
recent device driver available from the World
Wide Web.
v Run the network diagnostic program.
Diagnostics
25