IBM Netfinity 5100 8658 21Y, Руководство пользователя

Страница: 85 / 246

4. To install the drive, go to “Installing a hot-swap drive”
or to “Installing a non-hot-swap drive” on page 78, as
appropriate.
Installing a hot-swap drive
1
Filler panel tray for use with half-high drives
2
Slim filler bezel
3
Hard disk drive
4
Drive tray
5
Drive tray handle (in open position)
Attention: To maintain proper system cooling, do not
operate the server for more than two minutes without
either a drive or a filler panel installed for each bay.
To install a drive in a hot-swap drive bay:
1. If your hard disk drive is not installed on the drive tray,
place the drive in the drive tray and, being careful not
to over-tighten the screws , attach the drive to the
tray using the four screws provided with the option kit.
2. Remove the filler panel from one of the empty
hot-swap bays by inserting your finger into the
depression at the left side of the filler panel and pulling
it away from the server.
Note: If you are installing a half-high hard disk drive,
you will need to remove two adjacent filler
panels. The two filler panels should be from
either the top pair of bays, the middle pair of
bays, or the bottom pair of bays.
3. Install the hard disk drive in the hot-swap bay:
a. Ensure the tray handle is open (that is,
perpendicular to the drive).
Installing options
75