IBM Netfinity 5100 8658 21Y, Руководство пользователя

Страница: 75 / 246

Removing the cover (rack model)
Note: To remove or install a hot-swap hard disk drive or
hot-swap power supply, it is not necessary to
remove the cover.
1
Top cover
2
Right side latch
3
Cover release lever
4
Left side latch
To remove the server top cover:
1. Review the information in “Before you begin” on
page 61.
2. If you are planning to install or remove any part other
than a hot-swap hard disk drive or hot-swap power
supply, turn off the server and all attached devices and
disconnect all external cables and power cords.
3. Release the left and right side latches and pull the
server out of the rack enclosure until both slide rails
lock.
Note: When the server is in the locked position, you
can reach the cables on the back of the server.
4. Move the cover-release lever down while sliding the
top cover toward the rear of the server about 25 mm (1
inch). Lift the cover off the server and set the cover
aside.
Attention: For proper cooling and airflow, replace the
cover before turning on the server.
Operating the server for extended periods
of time (over 30 minutes) with the cover
removed might damage server
components.
Installing options
65