IBM N7700, Руководство по аппаратуре и обслуживанию

Страница: 81 / 182

If your system is running... Then...
Data ONTAP 8.0.1 and later Complete the following substeps:
1. Enter
n
to skip the backup recovery when you see the following prompt:
**************************************************************
*
Restore Backup Configuration *
* This procedure only applies to storage controllers that *
* are configured as an HA pair. *
* *
* Choose Yes to restore the ’varfs’ backup configuration *
* from a TFTP server. Refer to the Boot Device Replacement *
* guide for more details. *
* Choose No to skip the back up recovery and return to the *
* boot menu. *
**************************************************************
Do you want to restore the backup configuration
now? {y|n} n
Note: If your system is running Data ONTAP 8.1.1 and later, the prompt
says
SSH server
.
2.
Reboot the node by entering
y
when you see the following prompt:
The node must be rebooted to start using the newly installed
software. Do you want to reboot now? {y/n} y
The controller module reboots, but stops at the boot environment
prompt.
3. Boot Data ONTAP by entering the following command at the boot
environment prompt:
boot_ontap
The controller module reboots, but stops at the Boot menu because the
CompactFlash card was reformatted and the configuration data needs to
be restored.
15. Select the Update flash from backup config option from the displayed menu.
16. Enter
y
when you see the following prompt:
This will replace all flash-based configuration with the last backup to
disk. Are you sure you want to continue?: y
The system automatically reboots when the update flash (syncflash) process is
complete.
17. Your next step depends on your system configuration.
If your system is... Description
A stand-alone configuration You can begin using your system after the
node reboots to complete restoring the
backup configuration.
Chapter 5. Replacing N7000 series system devices
55