Reference Code
Description/Action Perform all actions before exchanging Failing Items
Failing Item
2610
Processor/Memory Card not installed
2612
Optical Converter 5V Fault
The SPCN detected a fault on the SPCN card optical converter 5V.
2613
Configuration Requires 200V Input
Configuration now requires 200V AC power.
300E
EPO Circuit Fault
The ac module installed in the 9406 Expansion Unit (FC 504x) detected a
fault in the UEPO signal. The signal was active and the incoming ac
voltage was still present.
TWRCARD
21F9362
21F5680
302B
PCC Overcurrent
The power control compartment is causing an over current condition in the
9406 Expansion Unit power system.
Exchange the ac module and the SPCN port cable at the same time.
TWRCARD
21F5680
21F9631
21F9362
3100
I2C Bus Controller Communication fault
3101
I2C Bus 1 Communication fault
3102
I2C Bus 2 Communication fault
3103
I2C Bus 3 Communication fault
3104
I2C Bus 4 Communication fault
3105
I2C Bus 5 Communication fault
3106
I2C Bus 6 Communication fault
3110
I2C Bus DASD Backplane 1 Communication fault
3111
I2C Bus DASD Backplane 2 Communication fault
3112
I2C Bus DASD Backplane 3 Communication fault
3113
I2C Bus Adapter Communication fault
3114
I2C Bus PCI Backplane Communication fault
3115
I2C Bus Panel Communication fault
3116
I2C Bus Fan Local Controller Communication fault
3117
I2C Bus Fan Remote Controller Communication fault
3118
I2C Bus SPCN VPD Communication fault
1xxx
96
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference Codes)
