IBM HS21 - BladeCenter - 8853, Руководство по диагностике и обслуживанию

Страница: 80 / 140

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Types 1885 and 8853,” on page 73 to determine which components are CRUs
and which components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
217-xxx-001 Failed hard disk drive test.
Note: If RAID is configured, the SAS
Attached Disk number refers to the RAID
logical drive.
1. Reseat hard disk drive 2.
2. Replace hard disk drive 2.
405-xxx-000 Failed Ethernet test on controller on the
system board.
1. Make sure that Ethernet is not disabled in the
Configuration/Setup Utility program.
2. (Trained service technician only) Replace the
system board assembly.
Recovering from a BIOS update failure
The blade server has an advanced recovery feature that will automatically switch to
a backup BIOS page if the BIOS code in the blade server has become damaged,
such as from a power failure during an update.
The flash memory of the blade server consists of a primary page and a backup
page. If the BIOS code in the primary page is damaged, the baseboard
management controller will detect the error and automatically switch to the backup
page to start the blade server. If this happens, a POST message Booted from
backup POST/BIOS image
is displayed. The backup page version may not be the
same version as the primary image.
You can then recover or restore the original primary page BIOS by using a BIOS
flash diskette.
To recover the BIOS code and restore the blade server operation to the primary
page, complete the following steps:
1. Download the latest version of the BIOS code from http://www.ibm.com/
bladecenter/.
2. Update the BIOS code, following the instructions that come with the update file
that you downloaded. This will automatically restore and update the primary
page.
3. Restart the blade server.
If that procedure fails, the blade server might not restart correctly or might not
display video. To manually restore the BIOS code, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 75.
2. Turn off the blade server.
3. Remove the blade server from the BladeCenter unit (see “Removing the blade
server from a BladeCenter unit” on page 77).
4. Remove the cover (see “Removing the blade server cover” on page 80).
5. If a Memory and I/O Expansion Blade is installed, remove it (see “Removing
an expansion unit” on page 82).
64
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide