IBM HS21 - BladeCenter - 8853, Руководство по диагностике и обслуживанию

Страница: 93 / 140

Removing the blade server from a BladeCenter unit
Attention:
v
To maintain proper system cooling, do not operate the BladeCenter unit without a
blade server, expansion unit, or blade filler installed in each blade bay.
v
Note the bay number. Reinstalling a blade server into a different bay than the
one from which it was removed could have unintended consequences. Some
configuration information and update options are established according to bay
number; if you reinstall the blade server into a different bay, you might have to
reconfigure the blade server.
To remove the blade server from a BladeCenter unit, complete the following steps.
The appearance of your BladeCenter unit might be different, see the documentation
for your BladeCenter unit for additional information.
Release handles
(open)
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 75.
2. If the blade server is operating, shut down the operating system; then, press the
power-control button (behind the blade server control panel door) to turn off the
blade server (see “Turning off the blade server” on page 6 for more information).
Attention: Wait at least 30 seconds, until the hard disk drives stop spinning,
before proceeding to the next step.
3. Pull the two release handles to the open position as shown in the illustration.
The blade server moves out of the bay approximately 0.6 cm (0.25 inch).
4. Pull the blade server out of the bay.
5. Place either a blade filler or another blade server in the bay within 1 minute.
Chapter 4. Removing and replacing blade server components
77