IBM HS21 - BladeCenter - 8853, Руководство по диагностике и обслуживанию

Страница: 35 / 140

v Follow the suggested actions in the order in which they are listed in the Action
column until the problem is solved.
v
See Chapter 3, “Parts listing, Types 1885 and 8853,” on page 73 to determine which
components are CRUs and which components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must
be performed only by a trained service technician.
Error message Action
BSE RAID fault
1. Reseat the ServeRAID SAS controller in
the BladeCenter Storage Expansion Unit
3.
2. Replace the following components one at
a time, in the order shown, restarting the
blade server each time:
a. ServeRAID SAS controller
b. BladeCenter Storage Expansion Unit
3
Memory module bus fault
1. Reseat the Memory and I/O Expansion
Blade
2. Replace the Memory and I/O Expansion
Blade system board
Firmware (BIOS) halted, System
management bus error
1. Update the blade server firmware.
2. Update the blade server and option
device drivers.
Power jumper not present If the blade server does not have a Memory
and I/O Expansion Blade installed, make
sure that the power jumper is correctly
installed in power connector J164.
PCI bus timeout- system error
1. Remove the blade server from the
BladeCenter; then, reinstall it.
2. Reseat all the options installed in the
blade server one, restarting the blade
server each time, at a time to determine
where the problem is located.
3. Remove options from the blade server
one at a time to determine where the
problem is located.
4. Replace the following components one at
a time, in the order shown, restarting the
blade server each time:
a. All options installed in the blade
server
b. (Trained service technician only)
System board assembly
Chapter 2. Diagnostics
19