g.
Take the second Px-T1 label from the expansion drawer label sheet and place it on the opposite
end of the cable greater than 100 mm (4 in) from the end of the cable (L). See Figure 17 on page
23.
10.
Place and route the labeled cable:
Remember:
Do not connect the cable now.
a.
Locate the connector end of the cable with the host system Cx-T1 label (E) and place it near the
T1 port on the PCIe3 cable adapter.
b.
Route the cable and place the connector end (K) near the I/O module on the EMX0 PCIe3
expansion drawer.
11.
Repeat steps 8 on page 22 - 10 for the other cable in the pair.
12.
If you need to label and route more cable pairs, repeat steps 8 on page 22 - 11.
13.
Continue with step 15.
14.
To place and route the expansion drawer cables, complete the following steps:
Remember:
Do not connect the cable now.
a.
Place the connector end of one of the expansion drawer cables near the T1 port on the PCIe3
cable adapter on the host system.
b.
Route the cable and place the opposite connector end near the I/O module on the EMX0 PCIe3
expansion drawer.
c.
Repeat this step for the other cable in the pair and for other cable pairs.
15.
To connect the expansion drawer cables to the PCIe3 cable adapter ports on the host system and to a
PCIe3 6-slot fanout module on the EMX0 PCIe3 expansion drawer, complete the following steps:
a.
Determine the first expansion drawer cable that you will connect. It is the cable that is located
near connector T1 on the PCIe3 cable adapter in the host system.
b.
Remove the protective cover from the connector on the expansion drawer cable. Hold the cable
housing (B) on the short edges with the index finger and thumb on one hand. Then, grasping the
cover on the long edge (A) with the index finger and thumb on the other hand, pull the
protective cover off. See Figure 18.
Note:
Keep your fingers close to the closed end of the protective cover.
c.
Connect the expansion drawer cable into the T1 connector on the PCIe3 cable adapter in the host
system.
Figure 18. Removing the protective cover from the connector on the expansion drawer cable
24
Power Systems: Installing the EMX0 PCIe Gen3 I/O expansion drawer
Содержание EMX0 PCIe3
