IBM EMX0 PCIe3, Установка

Страница: 36 / 72

13. To place and route the expansion drawer cables, complete the following steps:
Remember: Do not connect the cable now.
a.
Place the connector end of one of the expansion drawer cables near the T1 port on the PCIe3
cable adapter on the host system.
b. Route the cable and place the opposite connector end near the I/O module on the EMX0 PCIe3
expansion drawer.
c. Repeat this step for the other cable in the pair and for other cable pairs.
14. To connect the power cables for the EMX0 PCIe3 expansion drawer, complete the following steps:
a. Connect the power cables into the power source.
Important: Ensure that you plug the power cables into the power source before you connect
them into the power supply of the EMX0 PCIe3 expansion drawer.
b.
Route the power cables through the s-carabiner so that the cables clear the PCIe3 6-slot fanout
module or modules. See Figure 16.
c. Connect the other ends of the power cables into the power supplies on the EMX0 PCIe3
expansion drawer you are installing. See Figure 16.
15. To connect a pair of expansion drawer cables to the PCIe3 cable adapter on the host system and a
PCIe3 6-slot fanout module on the EMX0 PCIe3 expansion drawer, and to activate the link, complete
the following steps:
a. If you are using an HMC Classic or HMC Enhanced interface, complete the following steps:
1) Select Serviceability > Hardware > MES Tasks.
2) Continue with step 15c on page 21.
b. If you are using the HMC En Tech Preview (Pre-GA) or HMC E interface,
complete the following steps:
1)
In the navigation area, click the Resources icon, and then click All Systems.
Figure 16. Routing the power cables through the s-carabiner and connecting them to the power supply
20
Power Systems: Installing the EMX0 PCIe Gen3 I/O expansion drawer