Remember:
If your rack has square mounting holes, use the larger rail pins that are provided
with the rack installation kit.
c.
Extend the left rail and insert the rail pins (D) into the two lowest mounting holes that are marked
on the rack. Rotate up the front clamp (C) to secure the rail in place.
6.
Move to the rear of the rack, and complete the following steps:
a.
Extend the right rail, and insert the rail pins (D) into the two lowest mounting holes that are
marked on the rack. Rotate up the back clamp (C) to secure the rail in place.
b.
Extend the left rail and insert the rail pins (D) into the two lowest mounting holes that are marked
on the rack. Rotate up the back clamp (C) to secure the rail in place.
c.
Use two M5 screws (E), one below each rail pin (D) to secure the left rail to the back of the rack.
d.
Use two M5 screws (E), one below each rail pin (D) to secure the right rail to the back of the rack.
7.
Move to the front of the rack and complete the following steps:
a.
Use one M5 screw (E) below the lower rail pin (D) to secure the left rail to the front of the rack.
b.
Use one M5 screw (E), below the lower rail pin (D) to secure the right rail to the front of the rack.
Installing the EMX0 PCIe3 expansion drawer into the rack
Learn how to install the EMX0 PCIe3 expansion drawer into the rack. In addition to related safety
information, illustrations of the related hardware components are provided.
Important:
Three people are required to safely lift the drawer. Using fewer than three people to lift the
drawer can result in injury.
To install the drawer into the rack, complete the following steps:
1.
Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2.
Remove the four thumb screws (B) that are used to secure the shipping cover (A) to the rear of the
drawer, as shown in Figure 7 on page 11. Remove the shipping cover.
P8EGP512-0
D
E
Front
Back
C
D
C
E
Figure 6. Attaching the rails
10
Power Systems: Installing the EMX0 PCIe Gen3 I/O expansion drawer
Содержание EMX0 PCIe3
