IBM @Server pSeries 630 6C4, Руководство по обслуживанию

Страница: 489 / 651

Media Replacement
To replace a media drive, do the following:
1. Before handling any card, board, or memory DIMM, be sure to use your electrostatic discharge strap
to minimize static-electric discharge. Refer to “Handling Static-Sensitive Devices” on page 423.
2. Set any jumpers or switches on the device according to the documentation provided with the drive.
3. Using four retaining screws, secure the media carrier tray to the bottom of the media drive.
4. Insert the media drive into the media bay, pushing the drive in until the release tab clicks into the
locked position.
5. Connect the media signal and power cables to the drive.
6. Replace the bezel as described in “Front Bezel Replacement (Model 6C4)” on page 442 or “Front
Bezel Replacement (Model 6E4)” on page 443.
7. Replace the service access cover as described in “Service Access Cover Replacement (Model 6C4)”
on page 431 or “Service Access Cover Replacement (Model 6E4)” on page 437.
8. If you are servicing a Model 6C4, push the system drawer back into the operating position as
described in “Returning the Model 6C4 to the Operating Position” on page 430.
9. Reconnect the power source to the system.
10. Power on the system as described in “Starting the System without an HMC Attached” on page 425.
11. After the Model 6C4 has successfully powered on, close the rack doors.
After the Model 6E4 has successfully powered on, close the bezel door.
Chapter 9. Removal and Replacement Procedures
469