IBM @Server pSeries 630 6C4, Руководство по обслуживанию

Страница: 389 / 651

– Surveillance
Can be set to Enabled or Disabled.
– Surveillance Time Interval
Can be set to any number from 2 through 255.
– Surveillance Delay
Can be set to any number from 0 through 255.
Refer to “Service Processor System Monitoring - Surveillance” on page 399 for more information about
surveillance.
v
Reset Service Processor
If this option is selected, entering Y causes the service processor to reboot.
v Reprogram Flash EPROM Menu
This option requires a diskette drive to be installed in the system. If this option is selected, and no
diskette drive is present in the system, the service processor will indicate
″
Not Supported
″
on the
screen.
This option updates the system EPROMs. After entering
Y
to indicate that you want to continue, you are
prompted to enter the update diskettes. Follow the instructions on the screen. When the update is
complete, the service processor reboots.
All system EPROMs that can be reprogrammed are updated at the same time and are as follows:
– System power control network programming
– Service processor programming
– System firmware programming
– Run-Time Abstraction Services
v Serial Port Snoop Setup Menu
Note: This option is disabled in partitioned systems.
This menu can be used to set up serial port snooping, in which the user can configure serial port 1 as a
″
catch-all
″
reset device.
From the service processor main menu, select option 1, service processor setup menu, then select
option 8 (Serial Port Snoop Setup Menu).
SERIAL PORT SNOOP SETUP MENU
1. System reset string:
Currently Unassigned
2. Snoop Serial Port:
Currently Unassigned
98. Return to Previous Menu
1>
Use the Snoop Serial Port option to select the serial port to snoop.
Note: Only serial port 1 is supported.
Chapter 7. Using the Service Processor
369