IBM Aptiva 2198, Справочное руководство

Страница: 107 / 186

1. Start the Configuration/Setup Utility program (see “Starting and
using the Configuration/Setup Utility program” on page 27).
2. From the Configuration/Setup Utility program menu, select
Advanced Setup and press Enter.
3. Select PCI Control and press Enter.
4. Use the arrow key (
→
or
←
) to set the PCI Parity setting to
Disabled.
5. Press Esc until you return to the Configuration/Setup Utility program
menu.
6. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility menu and press Enter.
7. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Ÿ
Automatic power on
If you install a PCI adapter that supports an automatic power-on
function, you can enable the power-on function through the
Configuration/Setup Utility program. When the automatic power-on
function is enabled, the computer can be started remotely through a
network or through the telephone lines, depending on the type of
adapter installed. An example of this type of adapter is a modem that
supports the ring-detection function. To enable the PCI Wakeup
function:
1. Start the Configuration/Setup Utility program (see “Starting and
using the Configuration/Setup Utility program” on page 27).
2. From the Configuration/Setup Utility program menu, select Power
Management and press Enter.
3. Select Automatic Power On and press Enter.
4. In the PCI Wakeup line or the PCI MODEM Ring Detect line
(depending on the type of device), use the arrow key (
→
or
←
) to
set the setting to Enabled. Then, in the corresponding Startup
Sequence line, select either Primary (for primary power-on
sequence) or Automatic (for automatic power-on sequence). For
an explanation of the power-on sequence, see “Setting the startup
sequence” on page 36.
5. Press Esc until you return to the Configuration/Setup Utility program
menu.
6. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility menu and press Enter.
7. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Chapter 7. Installing internal options
85