Hypertherm ArcGlide Torch Height Control, Инструкция по эксплуатации

Страница: 62 / 208

2-26 ArcGlide THC Instruction Manual
INStALLAtIoN
2
1. Position the lifter on the gantry:
• Low enough that the torch can reach the workpiece.
• High enough that the torch does not touch the table.
• The bottom of the lifter must be within 20.32 cm (8.00”) of the thinnest
workpiece.
• Mounting holes have the same spacing as the Sensor THC and Command THC
lifters.
2. Mount the lifter on the gantry:
a. Remove the side panels to expose the mounting screw holes.
b. Loosely fasten the screws in a diagonal pattern, top to bottom and right to left
(see the numbers in the illustration on right.)
c. Use a minimum of 4 screws to mount the lifter.
d. Place a level vertically along the side of the lifter to verify that it is mounted
vertically.
e. Tighten the screws using a maximum torque of 0.9 newton meter (8.0 inch
pounds).
f. When they are tightened, the tops of the screws must be below the surface of the
back panel of the lifter so the side panels can be replaced.
g. Reinstall the side panels.
3. Connect the lifter interface cable and secure it.
a. The cable connector is not rated for hard use or constant flexing. Support the
cable and add enough slack to prevent strain on the cable and prevent damage to
the cable assembly, lifter connector, or both.
b. Use the cable clamp that is included with the lifter to secure the cable to either
side of the lifter with a generous service loop.
c. Connect the cable ground to the ground connector on the top of the lifter.
1
2
3
4
5
6
b
d
Level
Side
panel
Side
panel
b
a
c