Huawei Quidway S8500 Series, Руководство по управлению

Страница: 310 / 1341

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-8
not forward the routes of the interface using this command and it seems that the
interface disappeared.
When the network command is used on an address, the effect is that the interface on
the network segment at this address is enabled. For example, the results of viewing the
network 129.102.1.1 with both the display current-configuration command and the
display rip command are shown as the network 129.102.0.0.
Related command: rip work .
Example
# Enable the RIP on the interface with the network address as 129.102.0.0.
[Quidway-rip] network 129.102.0.0
2.1.9 peer
Syntax
peer ip-address
undo peer ip-address
View
RIP view
Parameter
ip-address : The interface IP address of the peer router, in dotted decimal format.
Description
Use the peer command to configure the sending destination address of the peer device.
Use the undo peer command to cancel the set destination address.
By default, do not send RIP packet to any destination.
RIP exchanges routing information with non-broadcasting networks in unicast view.
This command specifies the sending destination address to fit some non-broadcast
networks. Usually, it is not recommended to use this command.
Example
# Specify the sending destination address 202.38.165.1.
[Quidway-rip] peer 202.38.165.1
2.1.10 preference
Syntax
preference value