Huawei Quidway S8500 Series, Руководство по управлению

Страница: 410 / 1341

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Chapter 4 Integrated IS-IS Configuration Commands
Huawei Technologies Proprietary
4-35
Parameter
seconds : Duration of one cycle in seconds of SPF calculation in the range from 0 to 120.
When the calculation duration time reaches or exceeds the set value, the calculation of
this time ends. If seconds is set to 0, it indicates that SPF calculation is not divided into
slices and it will operate until the end. By default, the value is 0.
Description
Use the spf-slice-size command to enable IS-IS to calculate SPF routes in slices and
configure the duration of each calculation.
Use the undo spf-slice-size command to restore the default setting.
When there are a large number of routes in the routing table, this command can be
used to enable the SPF calculation in slices to prevent it from occupying the system
resources for a long time.
The user is recommended to use the command when the number of routes reaches
150,000 or 200,000 and the value of seconds is recommended as 1. In other cases, the
default setting should be used, that is, SPF runs to the end with no slice.
If the spf-delay-interval command is also configured, when SPF calculation is run, the
SPF calculation will be paused if any setting item is met.
Related command: spf-delay-interval .
Example
# Set the SPF duration time to one second.
[Quidway-isis] spf-slice-size 1
4.1.42 summary
Syntax
summary ip-address mask [ level-1 | level-1-2 | level-2 ]
undo summary ip-address mask [ level-1 | level-1-2 | level-2 ]
View
IS-IS view
Parameter
ip-address: Summarized network segment address.
mask : Summarized network mask.
level-1 : Summarizes the routes imported into Level-1.
level-1-2 : Summarizes the routes imported into Level-1 and backbone area.
level-2 : Summarizes the routes imported into backbone area.