Huawei Quidway S8500 Series, Руководство по управлению

Страница: 308 / 1341

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-6
Description
Use the host-route command to control the RIP to accept the host route.
Use the undo host-route command to reject the host route.
By default, RIP accepts the host route.
In some special cases, RIP receives a great number of host routes in the same network
segment. These routes cannot help the path searching much but occupy a lot of
resources. In this case, the undo host-route command can be used to reject a host
route.
Example
# Configure RIP to reject a host route.
[Quidway-rip] undo host-route
2.1.7 import-route
Syntax
import-route protocol [ cost value | route-policy route-policy-name ]*
undo import-route protocol
View
RIP view
Parameter
protocol : Specifies the source routing protocol to be imported by RIP. At present, RIP
can import the following routes: direct , bgp , ospf , ospf-ase , ospf-nssa , isis and
static .
value : Cost value of the route to be imported.
route-policy route-policy-name : Configures to import the route matching the condition
of the specified Route-policy only.
Description
Use the import-route command to import the routes of other protocols into RIP.
Use the undo import-route command to cancel the routes imported from other
protocols.
By default, RIP does not import any other route.
The import-route command is used to import the route of another protocol by using a
certain cost value . RIP regards the imported route as its own route and transmits it with
the specified cost value . This command can greatly enhance the RIP capability of
obtaining routes, thus increasing the RIP performance.