Huawei Quidway S8500 Series, Руководство по управлению

Страница: 737 / 1341

Command Manual – MPLS
Quidway S8500 Series Routing Switches
Chapter 1 MPLS Basic Configuration Commands
Huawei Technologies Proprietary
1-27
<Quidway>system-view
[Quidway] interface vlan-interface 201
[Quidway-Vlan-interface201] mpls ldp timer hello 30
1.2.18 mpls ldp transport-ip
Syntax
mpls ldp transport-ip { interface | ip-address }
undo mpls ldp transport-ip
View
VLAN interface
Parameter
interface : Sets the IP address of the current interface as the transport address.
ip-address : Sets the IP address as the transport address.
Description
Use the mpls ldp transport-ip command to configure an LDP transport address.
Use the undo mpls ldp transport-ip command to restore the default LDP transport
address.
By default, LSR ID is set as a transport address.
When there are multiple directly-connected and MPLS LDP-enabled links between two
LSR neighbors, all these links must be configured with the same transport address (it is
recommended to adopt the default LSR ID as the transport address). Otherwise, the
system may be unable to set up a steady LDP session.
For a Remote-peer, the transport address cannot be configured and is fixed to the LSR
ID.
By default, an LSR ID is the address of some Loopback interface and the Remote peer
can route to this address for a session. For a Local peer, the address of the local
interface or the Router ID of LSR can be adopted as its transport address.
Example
# Set the address of the current interface as a transport address.
<Quidway>system-view
[Quidway] interface vlan-interface 201
[Quidwa-Vlan-interface201] mpls ldp transport-ip interface
# Set the address of another interface as a transport address.
[Quidway-Vlan-interface201] mpls ldp transport-ip 10.1.11.2