Huawei Quidway S8500 Series, Руководство по управлению

Страница: 373 / 1341

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-53
Example
# Set the OSPF route calculation interval of Quidway to six seconds.
[Quidway-ospf-1] spf-schedule-interval 6
3.1.55 stub
Syntax
stub [ no-summary ]
undo stub
View
OSPF area view
Parameter
no-summary : ABR is disabled to transmit Summary LSAs to the Stub area.
Description
Use the stub command to configure an OSPF area as Stub area.
Use the undo stub command to cancel the settings.
By default, no area is set to be a Stub area.
If the router is an ABR, it will send a default route to the connected Stub area. Using the
default-cost command, you can configure the default route cost value.
In addition, on an ABR, you can configure the no-summary argument in the stub
command to prevent type-3 LSAs from entering the Stub area connected to this ABR.
Related command: default-cost .
Example
# Set the type of OSPF area 1 to the Stub area.
[Quidway-ospf-1] area 1
[Quidway-ospf-1-area-0.0.0.1] stub
3.1.56 vlink-peer
Syntax
vlink-peer router-id [ dead { seconds | minimal multi-hello packets } | retransmit
seconds | trans-delay seconds | hello seconds | simple password | md5 keyid key ]*
undo vlink-peer router-id