Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Chapter 5 Installing Cables
Huawei Technologies Proprietary
5-37
black straps and distribute it horizontally or vertically. Bend the cable into a circular
arc at the turning point.
z
Stick cables on power cable at 20 mm (0.8 in.) from both ends. For specifications
of cable labels, see Chapter 9, “Engineering Labels for Cables” in the
Airbridge
BT
S
3606&3606A CDMA Base Station Installation Manual – Installation
Reference.
5.7.2 Making Power Cables
Tools used to assemble power cables include: tape, wire nipper, paper knife, hydraulic
pliers, insulating tapes, soldering iron, and solder wire.
To make power cables, proceed as follows:
1)
Measure the distance from the input port of the lightning arrester to the
corresponding binding post of the power distribution box according to the cabling
route of power cables and grounding cables.
2)
Cut power cables and grounding cables according to the distance measured and
margins required.
3)
Cut the insulating cover of each cable head using the paper knife. The length of
the removed cover must be equal to that of the cable lug.
4)
Tighten the lug with hydraulic pliers.
5)
Coat the lug and the naked cable with insulating tape, as shown in Figure 5-38. Do
not expose the lug and the naked cable.
(1) The interval is not more than 1 mm (0.04 in.)
(2) Wrap up with tapes
(2) The naked stubs are covered with cable caps.
Figure 5-38
Making lugs
5.7.3 Connecting Power Cables
This section introduces how to connect power cables when the three-phase power
input and single-phase power input is used.
