24
HT130003 / HT130042
HT130030 / HT130043
User Manual
CorTemp
®
Data Recorder v4.3
9001 Series
B.7. MEM Message
When the recorder has stored approximately 25,000 readings, it will stop recording data
and the
EXIT / STBY
mode will display a
MEM
message. The collected data must be
downloaded to a PC / Laptop for graphing or analysis. Once the data is downloaded, you
may either "Clear Data" or "Initialize Recorder" to reset the
MEM
message.
C. Monitoring Heart Rate – Standard Menu
If your CorTemp
®
Data Recorder includes the heart rate option and heart rate will be
monitored, use of the POLAR
®
T31 (non-coded) Heart Rate Belt is required. Refer to the
diagram below for instructions on how to wear the POLAR
®
Heart Rate Belt:
1. Attach the transmitter to the chest belt (strap).
2. Adjust the strap length to fit snugly and
comfortably. Secure the strap around your
chest, just below the chest muscles, and
buckle it.
3. Lift the transmitter off your chest and
moisten
the two grooved electrode areas
on the
back.
4. Check that the wet electrode areas are firmly
against your skin and the Polar logo is in a
central, upright position.
NOTE: The Temperature Collection Interval must be set to a minimum of 20 seconds
in order to monitor heart rate.
D. Downloading Data – Standard Menu
D.1. Connecting the Data Recorder to a PC / Laptop
To connect the recorder to a PC / Laptop do the following:
