19
Ten-GigabitEthernet1/0/1
Ten-GigabitEthernet1/0/2
group-member
Use
group-member
to assign Ethernet interfaces to a port group.
Use
undo group-member
to remove Ethernet interfaces from the port group.
Syntax
group-member
interface-list
undo group-member
interface-list
Default
A port group does not contain any member ports.
Views
Port group view
Default command level
2: System level
Parameters
interface-list
: Specifies an Ethernet interface list, in the form of
interface-type interface-number
[
to
interface-type interface-number
] &<1-10>. &<1-10> indicates that you can specify up to 10 interfaces or
interface ranges.
Usage guidelines
If you use the
group-member
interface-type interface-start-number
to
interface-type interface-end-number
command to add multiple ports in batches to the specified port group, make sure the following:
•
All these ports are of the same type and on the same interface card.
•
The
interface-end-number
argument is greater than the
interface-start-number
argument.
Examples
# Assign Ten-GigabitEthernet 1/0/1 to the port group named
group1
.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member ten-gigabitethernet 1/0/1
multicast-suppression
Use
multicast-suppression
to set the multicast suppression threshold on an Ethernet interface or a group
of Ethernet interfaces.
Use
undo multicast-suppression
to restore the default multicast suppression threshold.
Syntax
multicast-suppression
{
ratio
|
pps
max-pps
}
undo
multicast-suppression
