HP A-F5000, Руководство по началу работы

Страница: 32 / 145

26
To do… Use the command… Remarks
Enter the
default ISP
domain view
domain domain-name
Specify the
AAA scheme to
be applied to
the domain
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
Configure
the
authentic
ation
mode
Exit to system
view
quit
Optional
By default, the AAA scheme is
local .
Create a local user and
enter local user view
local-user user-name By default, no local user exists.
Set the local password
password { cipher |
simple } password
Required
By default, no local password is set.
Specifies the command level
of the local user authorization-attribute
level
level
Optional
By default, the command level is 0.
Specify the service type for
the local user
service-type telnet
Required
By default, no service type is specified.
Exit to system view quit —
Configure common settings
for VTY user interfaces
—
Optional
See “
Configuring common settings for VTY user
interfaces (optional) .”
After you enable command authorization or command accounting, you need to perform the following
configuration to make the function take effect:
•
Create a HWTACACS scheme, and specify the IP address of the authorization server and other
authorization parameters.
• Reference the created HWTACACS scheme in the ISP domain.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
• When the AAA scheme is local, the user privilege level is defined by the authorization-attribute
level level command.
•
When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the
RADIUS or HWTACACS server.
When you log in to the device through Telnet again:
•
You are required to enter the login username and password. A prompt such as <HP> appears after
you enter the correct username (for example, admin) and password and press
Enter , as shown in
Figure 20 .
• After you enter the correct username and password, if the device prompts you to enter another
password of the specified type, you will be authenticated for the second time. In other words, to
pass authentication, you must enter a correct password as prompted.