HP 70340A, Руководство пользователя

Страница: 391 / 445

The data for the low band YIG calibration could not b e written to EEPR OM. Make
sure the PG switch on the pro cessor b oard w as closed during the cal and re-try the
calibration.
779 779,"Only 2GHz or 10GHz allow ed for YTO Cal;(779)"
The start frequency sp ecied for the CAL:YIG:FREQ:ST AR T command w as not v alid.
Re-en ter the start frequency and start the YIG calibration again.
785 785,"Cal Data not sa v ed, PG switch is not 0;(785)"
The calibration data could not b e sa v ed b ecause the PG switch on the micropro cessor
b oard w as not closed. Close the PG switch and do the calibration again.
786 786,"Cal Data v erication after EEPROM write;(786)"
The calibration data w as not written correctly after the calibration. Close the PG
switch and do the calibration again.
787 787,"FM cal and Pinc ho cal not initialized;(787)"
The YIG calibration has not b een done for b oth YIG bands or else the pinc ho cal
v alues ha v e not b een en tered y et.
790 790,"Scan-mo d 0.01-1 GHz gain tables bad;(790)"
Chec ksum w as in v alid for the AM gain tables. If y ou need to use this frequency range
and scan AM mo dulation, see the explanation for error n um b er 4000.
793 793,"Scan AM cal not v alid, defaults used;(793)"
Scan AM lev el may b e in error due to in v alid calibration data. If y ou need to use scan
AM mo dulation, see the explanation for error n um b er 4000.
794 794,"Scan-mo d 1-20 GHz gain tables bad;(794)"
Chec ksum w as in v alid for the AM scan gain tables. If y ou need to use this frequency
range and scan AM mo dulation, see the explanation for error n um b er 4000.
795 795,"Scan-mo d 1-20 GHz linear 1 tables bad;(795)"
Chec ksum w as in v alid for the AM scan linear 1 tables. If y ou need to use this frequency
range and scan AM mo dulation, see the explanation for error n um b er 4000.
796 796,"Scan-mo d 1-20 GHz linear 2 tables bad;(796)"
Chec ksum w as in v alid for the AM scan linear 2 tables. If y ou need to use this frequency
range and scan AM mo dulation, see the explanation for error n um b er 4000.
800 800,"Options not sa v ed, PG switch is not 0;(800)"
The instrumen t option bit-elds w ere not sa v ed to EEPR OM. Op en up the signal
generator, switch the PG switch to 0, and try setting the option bit-elds again.
801 801,"Serial n um not sa v ed, PG switch is not 0;(801)"
The instrumen t serial n um b er w as not sa v ed to EEPR OM. Op en up the signal
generator, switch the PG switch to 0, and try setting the serial n um b er again.
900 900,"PRI increased to t pulse width;(900)"
The curren t pulse width is to o large for the curren t PRI. The PRI is increased to allo w
for the pulse width. This is a \p ermanen t" error.
Error Messages 8-13
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com