Hotpoint MSZ900DFUK, Информация о сервисе

Страница: 48 / 61

48 of 61
Indesit Company
Service Manual UK English
ZA. DRINKS DISPENSER WATER FEED PIPE/TUBE (Refer to section ZE on Page 49 water tube
removal)
1. Remove the lower plinth/grille (2 screws).
2. Disconnect the water tube from left lower side behind the removed plinth.
3. Remove the dispenser grille from below the dispensing levers and remove the 2 screws.
4. Ease the control panel / dispenser box away from clips.
5. Disconnect the edge connectors.
6. Remove the dispenser box / frame.
7. Release the water pipe connection in the dispenser.
8. Pull the pipe all the way out of the hole to the left of the dispenser.
Note: To replace the water tube, push it down the hole to the left of the dispenser and reconnect it
at the front base of the appliance.
ZB. EMITTER AND RECEIVER BOARD - 2010 DF
MODELS
1. Lift the icemaker flap to access the top screws of either
emitter or receiver casing. Remove three screws in total,
again for either casing.
2. Use a chisel knife or similar tool to prise the casing from
its seal and the freezer liner.
Note: Receiver - When replacing, inspect and repair
any foam tape if required. Be aware not to trap wires.
Locate rear lug back into position before the pushing the
front of the casing back and screwing the receiver back
to the right side of the freezer liner.
Note: Emitter - When replacing, note the spring ends at
the front need pushing in before pushing in the rear of
the board cover back. Screw the emitter back to the left side of the freezer liner.
ZC. FRIDGE DOOR SWITCH (located in the right side liner of the fridge)
1. While protecting the liner underneath the switch from scratches,
remove the switch using a chisel knife of similar tool to prise the clip
inwards as indicated by the red arrow in the photo opposite. This clip
is located on the long underside of the switch towards the rear half
of the switch. The two terminals will be at the top rear of the switch
so remove the underside of the switch first.
ZD. FREEZER DOOR SWITCH (located in the top front inner panel in freezer)
1. Whilst protecting the liner on the right side of the switch from scratches, remove the switch using a
chisel knife of similar tool to prise the internal clip inwards. This clip is located on the right side rear
half of the switch. The four terminals are located on the left side so twist the clipped right side of
the switch out first.
Emitter
Receiver
Icemaker: view from behind cover
Fig. 19
Fig. 20