46 of 61
Indesit
Company
Service Manual UK
English
S.
PLASTIC DEFROST WATER EVAPORATION / DISSIPATOR TRAY
1.
Remove the components as in P and R.
2.
The tray can now be removed from the right rear of the appliance.
T.
CONDENSER FAN MOTOR (Refer to section ZE on Page 49 for water tube removal)
1.
Release the 2 screws securing the lower plinth/grille beneath the doors.
2.
Disconnect the water tube feeding the in-line connector below the freezer door.
3.
Remove the compressor cover as in P above.
4.
Release the screw securing the plastic frame of the condenser fan to the back of the appliance.
5.
Disconnect the ice and water tubes at the solenoid (yellow and blue collar).
6.
Draw the three water tubes through the plastic frame.
7.
Disconnect the connections to the motor - This is best done at the module.
8.
Lay the plastic frame and motor over at the top toward the solenoid valves. Manoeuvre the
assembly to remove from the lower brackets and release.
U.
POWER MODULE
1.
Remove the cover as in P.
2.
Remove the 2 screws securing the module and cover to the rear right hand edge of the cabinet.
3.
Prise the cover from the module box to gain access.
V.
FRIDGE DAMPER (BAFFLE)
1.
Locate the centre air filter cover / vent on the fridge rear inner wall. To remove the centre air filter
cover / vent lift up and off the four locating lugs.
2.
Remove the 1 screw in the centre behind the air filter cover / vent.
3.
Remove right hand lamp cover to assist the dismantling of the light box / damper housing unit, as
it allows it to flex slightly and give a more easy removal.
4.
Slide the light box / damper housing unit outwards to the right and forward and rest it on the runner
below it to ease the disconnection of the lamp wiring connection located on the left side. Now the
light box / damper housing unit can be removed.
5.
Disconnect the wiring from the damper motor.
6.
Remove damper assembly. Check the seal is in place on reassembling.
W. CONTROL PANEL INTERFACE / DISPENSER (Refer to section ZE on Page 49 water tube
removal)
1.
Lift the water dispenser grille from below the dispensing levers and remove the 2 screws.
2.
Ease control panel / dispenser box away from clips.
3.
Disconnect all edge connectors.
4.
Remove dispenser box / frame.
5.
Release the dispenser water tube by the yellow collar.
6.
Remove 2 screws on the top of the white dispenser
7.
Pull 2 clips inwards, located to the far right and far left of the clear plastic housing shown by the red
arrows in Figs. 17 and 18 overleaf.
