Horizon Reverse Osmosis Seafari Escape 200, Руководство пользователя

Страница: 56 / 126

long-term shutdown procedure requires 10 gallons (38 liters) of potable water. Follow the directions
listed below.
Important: If the system will be exposed to freezing temperatures during non-use, have ready
(1 gallon / 3.8 liters) food-grade glycerin (propylene glycol), and follow instructions to add it
to the storage chemical solution. This prevents the water in the system from freezing.
1. Configure the system for a “Once-Through Depressurized Rinse” using the Product Relief Tube
Kit.
2. Close the Inlet Sea Cock Valve.
3. Clean the Sea Strainer Mesh Screen.
4. Clean the Plankton Filter Element.
5. Replace the prefiltration cartridges with new 25- and 5-micron Sea Recovery prefiltration elements.
6. Fill the Rinse/Clean Solution Container with non-chlorinated product water.
7. Start the system. The rinse water rinses the entire system and discharge to waste.
8. Just prior to depleting the rinse water from the Rinse/Clean Solution Container, stop the system
by pressing the “START/STOP” switch twice to stop the system and also to abort the freshwater
flush cycle.
9. Once again, fill the Rinse/Clean Solution Container with non-chlorinated product water.
10. Add ONLY 4 ounces (1/6th of the container) of SRC SC storage chemical to the water in the
Rinse/Clean Solution Container.
11. Mix and thoroughly dissolve the solution in the Rinse/Clean Solution Container.
12. If the system will be exposed to freezing temperatures, add 1-gallon (4 liters) food-grade glycerin
(propylene glycol) to the storage solution mixture. This prevents the system from damage in freezing
temperatures.
13. Operate the system by pressing the “START/STOP” switch. The storage chemical solution flows
from the container, through the system, and out the brine discharge thru-hull fitting.
14. Discard any remaining winterizing solution in a safe, environmentally friendly and legal manner.
15. Reconfigure the system for normal operation:
a) Leave the Sea Cock Valve closed.
b) Reconnect the Sea Strainer outlet line to the outlet of the Sea Strainer or reposition the Inlet
Clean Rinse Valve to the normal operating position.
c) Remove the Product Relief Tube Kit.
d) Reconnect the High-Pressure Hose.
16. The Sea Strainer and post-filtration chapter have not received storage and winterizing solution in
this process. The water must be drained from the respective components.
a) Remove the Sea Strainer bowl from the Sea Strainer and drain the feed water from it. Replace
the Sea Strainer bowl back onto the Sea Strainer.
b) Remove the charcoal filter bowl from the charcoal filter, clean the inside of the bowl and replace
the element with a new Horizon Reverse Osmosis charcoal filter element.
c) Remove the pH neutralizer filter bowl from the pH neutralizer filter, drain the product water from
it and clean the inside of the bowl. Replace the pH neutralizer bowl back onto the pH neutralizer
filter.
d) Disconnect the top and bottom tube fittings from the ultraviolet sterilizer and drain the product
water from the UV sterilizer chamber. Reconnect the top and bottom tube fittings back onto the
UV sterilizer.
Seafari Escape 200-600 56