Horizon Reverse Osmosis Seafari Escape 200, Руководство пользователя

Страница: 35 / 126

Caution: Product water may spill during filter element replacing. Therefore, do not mount
the charcoal filter above any electrical or electronic component.
13. The ***pH Neutralizing Filter is mounted in an accessible location to a vertical bulkhead after the
Charcoal Filter and prior to the UV Sterilizer.
Caution: Product water may spill during filter element replacing. Therefore, do not mount
the pH Neutralizing Filter above any electrical or electronic component.
14. The ***UV Sterilizer is mounted to a bulkhead directly after the Charcoal Filter, or after the pH
Neutralizing Filter if used. The UV Sterilizer should be mounted vertically with the electrical fitting
on the top. The UV should be plumbed with the inlet on the bottom and the outlet on top. Horizontal
mounting is acceptable with outlet port on top (pointed up) to displace air. Do not mount the UV
Sterilizer with the electrical fitting on the bottom.
15. The ***Discharge Rinse Clean Valve is mounted in an accessible location between the System
Brine Discharge Outlet and the Brine Discharge Thru-Hull Fitting. Mount this valve in an accessible
location.
16. The ***Remote Controller is mounted to a flat surface with appropriate cut out for flush mounting
to the flat surface. Mount the Remote Controller in a protected area away from water spray.
Electrical Connections
1. Remove the front cover from the system controller to access the Main Terminal Strip and PC Board.
2. Connect main power using cable recommendations. The main power cable is inserted through one
of the large strain reliefs on the bottom of the controller enclosure. For AC systems only, the boat’s
12 VDC power source is also inserted through a small strain relief indicated on the diagram below.
3. Connect the Booster Pump motor power through the other large strain relief on the bottom of the
controller enclosure to terminals.
4. Connect the Freshwater Flush (FWF) Boost Pump using the supplied cable. Loosen the FWF strain
relief on the controller enclosure and insert the cable.
5. Connect UV Sterilizer using supplied purple cable. Loosen the other small strain relief on the bottom
of the controller enclosure and insert the purple cable. Connect to the PC Board.
6. Remote Control: Close supplied square relief around the flat cable and snap together. Insert into
square cutout on bottom of controller. Connect other end to modular plug on PC Board. Connect
the 3/4” Elbow to the Inlet Thru-Hull Fitting or the Sea Cock Valve. The installer should use common
sense when installing the Inlet Thru-Hull Fitting, the Sea Cock Valve and the Inlet Elbow assembly.
Hose Lines
REJECT WATER 5/8” HOSE LINE
Use the 5/8” braided hose to connect the 1/2” hose barb on the ETD outlet labeled “S” to the 1/2” hose
barb on the Reject Water Assembly. The Reject Water Assembly should be connected to the Thru-Hull
Discharge Fitting.
PRESSURE LINES - 1/4” BLACK TUBE
Use the 1/4” black tube to connect the tube connection on the Booster Pump to the Vacuum Gauge
on the Prefilter Assembly. Use the 1/4” black tube to connect the tube connection on the first Inline
35
Installation