Horizon Reverse Osmosis Seafari Escape 200, Руководство пользователя

Страница: 29 / 126

Chapter
5
Pre-Installation Safety
Ensure that you-as the Installer, Operator or both-read and understand the prerequisites, warnings and
important notes within this topic.
Storage Prior to Uncrating
You must adhere to the following crate markings:
• DO NOT store in direct sunlight
• DO NOT store above 120ºF (50ºC)
• DO NOT allow the System to freeze (do not store below 32ºF (0ºC))
• DO NOT store longer than four (4) months without flushing with storage chemical
• Store only on base with ARROWS UP
• Keep the RO Membrane Element wet at all times
Uncrating
• DO NOT DISCARD ANY PACKAGING UNTIL YOU HAVE FOUND AND IDENTIFIED ALL PARTS!
• Remove the Seafari Escape system from the shipping carton. Note that some of the components
are loose and/or separately packaged in the shipping container.
• Refer to the Illustrated Packing List pages to identify and confirm the contents of the Shipping Crate.
• USE CAUTION WHEN TROUBLESHOOTING. DO NOT PERFORM MAINTENANCE UNLESS THE
FOLLOWING CONDITIONS ARE MET:
• The System Feed Water Sea Cock Valve is closed.
• The system main electrical disconnect switch is switched OFF, LOCKED, and TAGGED.
• CAUTION: ELECTRICAL SHOCK HAZARD! A Volt / Ohm Meter will be necessary. The Installation
procedures expose the Installer to High Voltage and electrical shock hazard. Only attempt this if you
are a qualified electrician and only if surrounding conditions are safe.
Tools required for Installation
Not all installations are typical; therefore, it is recommended to have a full set of Mechanic’s, Plumber’s,
and Electrician’s tools available. No special system tools are required for installation. A separate TDS
Meter, available from Horizon Reverse Osmosis, will assist in confirming System product water quality.
A volt/ohm meter (VOM) is required for system installation and commissioning to ensure proper
electrical power and connection.
29