Horizon Reverse Osmosis Seafari Escape 200, Руководство пользователя

Страница: 34 / 126

5. The ***Inlet Rinse Clean Valve is mounted in an accessible location below water level between the
Sea Strainer Outlet and the ***Fresh Water Flush Check Valve Inlet if used, otherwise the Booster
Pump Inlet.
6. The Booster Pump is mounted at or below water level to assist the pump in priming. Mount the
Booster Pump between the Sea Strainer Outlet and the ***Plankton Filter Inlet if used, otherwise
the Prefilter Inlet. It is best to mount the Booster Pump below water level to assist priming and in
an accessible location to allow access for maintenance.
Caution: Do not mount the pump head vertically above the motor, as motor damage will
occur if the pump or its fittings should develop a leak. Eventually, the pump seal will wear
and leak from use requiring replacement. Water damage to the motor, if mounted improperly,
is the responsibility and liability of the installer and not covered by Horizon Reverse Osmosis
Warranty
Caution: Mounting of the Booster Pump above water level will cause a vacuum at the
inlet of the pump and will result in premature wear resulting from cavitation. Improper
installation of the Booster Pump causing excessive vacuum at the inlet of the pump resulting
in cavitation and premature wear is the responsibility and liability of the installer and not
covered by the Horizon Reverse Osmosis Warranty.
7. The ***Freshwater Flush Filter Canister with attached Flush Pump is mounted in an accessible
location to a vertical surface between an unpressurized line in the potable water system and the
Freshwater Flush Check Valve. Allow at least 4 inches (10 cm) of clearance below the bowl for
element replacement.
Caution: Potable water may spill during filter element replacing. Therefore, do not mount
the Prefilter above any electrical or electronic component.
8. The ***Freshwater Flush Check Valve Assembly is mounted vertically in close proximity to the
outlet of the Feed Water Pump and the inlet of the Plankton Filter or 25-micron Prefilter.
9. The ***Plankton Filter is mounted in an accessible location to a vertical surface between the Booster
Pump Outlet and the Prefilter Inlet, which is mounted to the system frame. Allow at least 4 inches
(10 cm) of clearance below the bowl for element replacement.
Caution: Feed water may spill during filter element replacing. Therefore, do not mount
the plankton filter above any electrical or electronic component.
10. The Prefilters are mounted to the system frame. They may be removed from the system frame and
mounted separately in an accessible location to a bulkhead. Allow minimum 4 inches (10 cm) below
the bowl for filter element removal.
Caution: Feed water may spill during filter element replacing. Therefore, do not mount
the Prefilter above any electrical or electronic component.
11. The system frame is mounted in an accessible location to a flat surface allowing ease of access
to controls and for maintenance.
12. The Charcoal Filter is mounted in an accessible location to a vertical bulkhead. Allow minimum 4
inches (10 cm) below the bowl for filter element removal.
Seafari Escape 200-600 34