Horizon Reverse Osmosis Seafari Escape 200, Руководство пользователя

Страница: 55 / 126

b) Reconnect the Sea Strainer outlet line to the outlet of the Sea Strainer, or reposition the Inlet
Clean Rinse Valve to the normal operating position.
IN NON-FREEZING TEMPERATURES THE SYSTEM MAY NOW BE LEFT UNATTENDED FOR
SEVERAL WEEKS. A GUIDE WOULD BE 4 WEEKS IN WARM CLIMATES AND 8 WEEKS IN
COLD CLIMATES. HOWEVER, IF THE SYSTEM WILL BE EXPOSED TO FREEZING
TEMPERATURES, CONTINUE WITH THE FOLLOWING PROCEDURES:
9. If the system will be exposed to freezing temperatures during non-use of the system, configure the
system for a “Once-Through Depressurized Rinse” using the Product Relief Tube Kit
10. Again, fill the Rinse/Clean Solution Container or a 5-gallon bucket with 4 gallons (15 liters) of clean,
freshwater. Add 20% (1 gallon/3.8 liters) food-grade propylene glycol to the storage chemical
solution. This prevents the water in the system from freezing.
11. Press the “START/STOP” switch. The winterizing solution rinses the system and discharges out
the waste.
12. Just prior to depleting the winterizing solution from the Rinse/Clean Solution Container, stop the
system by pressing the “START/STOP” switch twice (2 times) in order to stop the system as well
as deactivate the freshwater flush cycle. Ensure that the “freshwater flush” lamp is NOT illuminated.
13. Reconfigure the system for normal operation:
a) Leave the Sea Cock Valve closed.
b) Reconnect the Sea Strainer outlet line to the outlet of the Sea Strainer or reposition the Inlet
Clean Rinse Valve to the normal operating position.
c) Remove the Product Relief Tube Kit.
d) Reconnect the High-Pressure Hose.
14. The Sea Strainer and post-filtration chapter have not received winterizing solution in this process.
The water must be drained from the respective components.
a) Remove the Sea Strainer bowl from the Sea Strainer and drain the feed water from it. Replace
the Sea Strainer bowl back onto the Sea Strainer.
b) Remove the charcoal filter bowl from the charcoal filter and drain the product water from it.
Replace the charcoal filter bowl back onto the charcoal filter.
c) Remove the pH neutralizer filter bowl from the pH neutralizer filter and drain the product water
from it. Replace the pH neutralizer bowl back onto the pH neutralizer filter.
d) Disconnect the top and bottom tube fittings from the ultraviolet sterilizer and drain the product
water from the UV sterilizer chamber. Reconnect the top and bottom tube fittings back onto the
UV sterilizer.
e) Disconnect the freshwater line from the potable water storage tank to the freshwater flush pump
or if a valve is installed in this line close it to isolate the potable water line from the freshwater
flush pump.
f) Remove the Fresh Water Flush Charcoal Filter bowl and drain it. Replace the Fresh Water Flush
Charcoal Filter bowl back onto the Fresh Water Flush Charcoal Filter.
IN FREEZING TEMPERATURES THE SYSTEM MAY NOW BE LEFT UNATTENDED DURING THE
FREEZING TEMPERATURE SEASON. AFTER THE SEASON,THE SYSTEM SHOULD BE RINSED
WITH STORAGE CHEMICAL IF IT WILL NOT BE OPERATED.
Long-Term Shutdown
A long-term or prolonged shutdown is a period in which the system is not used for longer than 3 to 4
months, depending on conditions. For this interval, the system should first be rinsed with freshwater,
then stored with System and Membrane Element Storage Chemical (SRC SC). This chemical inhibits
bacterial growth while maintaining the high flux and salt rejection of the RO Membrane Element. The
55
System Storage and Cleaning