S-4
The following section contains in-depth details regarding each
of the available programming functions. If you’re just getting
started, you’ll likely find it easier (and we recommend) using
the Applications Guide included separately with your 12X
system. This step-by-step guide leads you through a typical
6-servo sailplane giving the key strokes necessary to set up a
sailplane, including flight modes, crow and side lever camber
adjustments. We recommend referring to the section below
when a more in-depth understanding of a specific programming
feature is desired.
System mode contains the foundational programming that is
normally only used when first setting up a Sailplane. System
mode functions include: model select, model name, model
reset, Wing type etc.—functions that are typically set once
during setup and then are seldom changed or adjusted. Below
and throughout this section, the functions are in the order that
they appear in the System Mode List.
Programming a Sailplane
System Mode
To Enter System Mode
Press ENT and hold while turning on the transmitter.
The screen should appear as follows.
SYSTEM MODE LIST
System mode contains the follow screens:
84: Model SEL
Model Select
Page S-5
81: MDL Name Model Name
Page S-7
28: MDL Reset
Model Reset
Page S-8
89: Type SEL
Type Select
Page S-8
85: MODULAT.
Modulation
Page S-9
(12X MV System Only)
93: Freq SEL.
Frequency Select
Page S-9
(12X MV System Only)
83: Trim SYS.
Trim System
Page S-11
91: STK Pos SW Stick Position Switch
Page S-13
92: FM Name
Flight Mode Name
Page S-14
86: Transfer
Model Transfer
Page S-15
97: Warning
Warning
Page S-17
98: Settings
Settings
Page S-18
17: Device SEL Device Select
Page S-18
22: Wing TYP
Swashplate Type
Page S-22
