Honeywell VISTA-128BPT, Инструкция по установке и настройке, Страница: 32 / 124

VISTA-128BPT/VISTA-250BPT Installation and Setup Guide
3-16
Installing the 5800TM Module
Installation of this module is necessary only if you are using a 5804BD Bi-directional device.
The address for the 5800TM must be enabled in the control’s Device Programming in the #93 Menu Mode as a
keypad and then assigned to a partition
.
To install the 5800TM, perform the following steps:
Step Action
1 Mount the unit using its accompanying mounting bracket near the RF receiver.
The 5800TM must not be installed within the control cabinet. It must be between one and two feet
from the receiver’s antennas.
2 Set the module for the appropriate address. For Address Setting 28 cut the red jumper; for Address 29 cut the
white jumper; for Address 30 cut both jumpers.
Make sure the address setting is not being used by another device (keypad, relay module, etc.).
3 Connect the module’s wire harness to the keypad terminals (6, 7, 8, and 9). Plug the connector at the other
end of the harness into the module.
House ID Sniffer Mode
This mode applies only if you are using a wireless keypad (e.g., 5827) or bi-directional devices (e.g., 5804BD). Use the
House ID Sniffer mode to make sure you do not choose a House ID that is in use in a nearby system. The House ID must
be programmed for the receiver in
Device Programming in the #93 Menu Mode.
To enter House ID Sniffer mode, enter your Installer Code + [#] + [2].
The receiver now “sniffs” for any House IDs in the area and displays them. Keep the receiver in this mode for 2 hours.
Use a House ID that is not displayed. Exit the Sniffer mode by entering your
Installer Code + OFF .
As Sniffer mode effectively disables RF point reception, Sniffer mode cannot be entered while any partition is
armed.
5800 Series Transmitters Setup
5800 Series transmitters have the following characteristics:
•
Transmitters have built-in serial numbers that must be enrolled in the system using the #93 Menu Mode
Programming , or input to the control via the downloader.
•
Transmitters do not have DIP switches (except 5827, described separately).
•
Some transmitters, such as the 5816 and 5817, can support more than one “zone” (referred to as loops or inputs).
Each loop must be assigned a different zone number.
•
For button-type transmitters (wireless keys), such as the 5804BD, you must assign a unique zone number to each
individual button used on the transmitter.
Transmitter Input Types
All transmitters have one or more unique factory-assigned input (loop) codes. Transmitters can be programmed as one
of the following types:
Type Description
RM
(RF Motion
)
Sends periodic check-in signals, as well as fault and low-battery signals. The control panel automatically restores the
zone to “ready” after a few seconds. This type is designed for facilities with multiple motion detectors that may fault and
restore simultaneously. The transmitter must remain within the receiver’s range.
NOTE: If using RF Motion with a door/window type transmitter, only loop 1 may be used.
RF
(Supervised
RF)
Sends periodic check-in signals, as well as fault, restore, and low-battery signals. The transmitter must remain within
the receiver’s range.
UR
(Unsupervised
RF)
Sends all the signals that the RF type does, but the control does not supervise the check-in signals. The transmitter
may therefore be carried off-premises.
BR
(Unsupervised
Button RF)
These send only fault signals. They do not send low-battery signals until they are activated. The transmitter may be
carried off-premises.