Configuring Events and Alarms
57
Table 6-2 Motion Detection Area Configurations
Parameter
Function
Sensitivity
Adjusts the brightness sensitivity. You might need to increase the brightness
sensitivity to trigger motion detection. You can configure up to four areas. The
sensitivity ranges from
0
to
100
. We recommend that you choose a sensitivity
between
30
to
70
. The default is
60
.
Threshold
The threshold determines how much change in a scene is required to trigger an
alarm. The lower the threshold setting, the easier it is to trigger a motion detection
alarm. You can configure up to four areas. The sensitivity ranges from
0
to
100
. We
recommend that you choose a sensitivity between
5
to
50
.
Remove All
Deletes all motion detection areas.
Delete
Deletes the selected motion detection area.
Configuring Camera Tampering Settings
Figure 6-4 Tampering Configuration Interface
Table 6-3 Tampering Configurations
Parameter
Function
Enable
Check to enable the
camera tampering
detection
function (
Video Tamper
and/or
Defocus Detect
).
Note Defocus Detect
is only supported by the following models:
HBW2PR2/HBW4PR2/HEW2PR2/HEW4PR2/H4W2PRV2/H4W4PRV2.
Working Period
The camera tampering function is activated during the specified period.
See
Configuring the Working Period
on page
You can configure up to six periods per day. Select a date. If you do not select
a date, the current setup will be applied to today only. You can select
All
to
apply the working period to the whole week.
Click
OK
to save the changes. The system goes back to the
Motion Detection
interface. Click
Save
to exit.
