Hologic R2 DM, Руководство пользователя

Страница: 45 / 106

3.7. Stopping Scanning and Removing a Case
3.7. Stopping Scanning and Removing a Case
You cannot ‘cancel’ a study, but if you don’t want to continue scanning the current
set of films, you can stop the system and remove any remaining films from the input
tray (as described below).
Note: This procedure can cause the system to produce an alert indicating there were
too few films. However, it is often faster to remove the films and produce the alert than
to wait for the films to be scanned and processed.
Important: If you changed the scanning protocol from its default setting before you
started scanning (e.g., if the default scanning protocol on the Controls Scanning screen is
Auto and you touched
Screening before touching Start ), the system resets the scanning
protocol to its default when you touch Stop in step 1 of the procedure below. If you
want to resume scanning with the non-default protocol after removing one or more
cases, you’ll need to select that scanning protocol again before touching
Start in step 6.
X
To stop scanning
1
Touch
Stop
. The scanner will stop after it finishes scanning the current film.
Note: If the system generates an alert, touch OK in the pop-up window.
2
Remove the entire stack from the input tray.
3
Remove the remaining films for the cancelled case.
4
As desired, remove any other case, that is, the separator sheet and the films associated
with it.
5
Place the remaining cases back in the input tray.
Important! Be sure that the next item to be scanned is the separator sheet for the
next case.
6
Select the desired scanning protocol, if not already selected.
7
Touch
Start
to resume scanning.
R2 DM User Manual – PN MAN-01044 Rev 001 37