Title
Drawing
NO
Area Designer
Instruction Manual
C-41-02495
51
／
51
Appendix A Network address
UXM-30LAH-EWA starts communication when Area Designer is connected with Ethernet. The
default setting of sensor’s IP address is 192.168.0.10. No need for special instruction as port
number is fixed. Also, IP address can be changed by using other address changing tool.
Appendix B Troubleshooting
While using this application and if a problem occurs, refer to the following table.
In case a problem be cannot resolved with any of the following methods listed, note the situation
and issue as well as when the problem occurred and contact the nearest sales representative or
distributor.
Situation
Symptoms
Possible reason
Solution suggestion
Non-supported OS
is used
Install in the OS supported
computer.
Free space of
Hard disk is not
sufficient
Free space of Hard disk must be
more than 100MB.
Cannot install the
application
All windows
program
have not been
closed
Close all the windows programs
except installer.
Installation
process
continuous
Please wait for a while.
Depending on the computer, the
installation process may require
some time.
When
installing the
application
Installation process
seems as stopped.
A message
dialogue is
displayed behind
the displayed
screen
Any hidden messages will be
displayed by pressing the “Alt key”
+ the “Tab key”, operate according
to the message.
Ethernet cable is
not connected
Make sure that sensor is
connected with the computer.
When Sensor
and PC
connected
Could not find the
sensor
Power supply is
OFF.
Power supply to the sensor.
