Title
Drawing
NO
Area Designer
Instruction Manual
C-41-02495
16
／
51
4.2.1.2.1 Independent
In this section, it explains how to configure the output of an independent
shape.
There are the 3 types: polygon, arc and rectangle. When one of these
independent shapes is selected, the point will be added to the center point of the
main view (refer to Fig. 4.2.1.2.1). By moving this point, a region of the selected
shape can be configured.
Fig
4.2.1.2.1 Default state during independent shape selection
When configuring an independent shape, there is a region where outputs can
be configured as well as a region where outputs cannot be configured. The
regions where an output can be configured are referred to as
configurable region.
The regions where outputs cannot be configured are referred to as an
un-configurable region.
As shown in Fig.4.2.1.2.1 the configurable area region is
in
white
while the un-configurable area region is in
gray
.
