Hobbico Awarf Series, Руководство пользователя

Страница: 6 / 40

6
Aileron servo tray mounting blocks
❑
1. Locate the 1/8" (3mm) die-cut plywood wing
joiners and separate the three individual joiners from
the die-cut plywood sheet using a hobby knife. Draw a
center line on both sides of the plywood
wing joiners
and aileron servo tray mounting blocks. Use one of
the plywood joiners as a template to mark the wing
dihedral angle on both of the balsa 5/16" x 1-7/16"
(8mm x 36mm) aileron servo tray mounting blocks.
Put these mounting blocks aside for use in Step
#
16.
Orientation of the wing joiners
❑
2. Arrange the three "V"-shaped plywood wing
joiners in the same orientation as they will be glued
together. Number each plywood wing joiner for
reference in the next step.
Gluing the wing joiner
❑
3. Mix approximately 1/4oz. (7.5ml) of 6-minute
epoxy. Using a mixing stick or epoxy brush, apply an
even coat of epoxy on both sides of the
#
2 wing joiner.
With the
#
3 wing joiner laying flat on the work surface,
stack
#
2 on top of
#
3 and
#
1 on the top of
#
2. Note : The
epoxy should be in between the layers of the plywood
wing joiners and not on the outside surfaces.
Clamping the wing joiner
❑
4. After epoxy has been applied to the
#
2 wing
joiner and the joiners have been laminated, use three
6
Assembling the Wing
What you'll need –
Parts in this kit • Rubbing alcohol
• 3 Plywood wing joiner pieces • Felt-tip pen
• Left and right wing halves • Ruler
• Wing center section tape • Sand paper
• 6 Brass hinges • Mixing sticks
• 2 Servo tray mounting blocks • Mixing cups
• Aileron servo tray • Masking tape
• Servo hole template • Petroleum jelly
• Covering removal template • Hobby knife
• 2 Aileron control horns • Clothespins
• 2 Plastic clevises • Paper towels
• 2 Aileron pushrods • CA+ glue
• Clear plastic tubing • 6-minute epoxy
...Plus, these general items: • 30-minute epoxy
• Epoxy brushes • Fine-toothed file
Center line
1
1
2
2
3
3
Actual Size
Servo Tray Block (2)