10
❑
19. Mix 1/8oz. (3.5ml) of 6-minute epoxy to glue
the servo tray to the bottom side of the wing. Apply
equal amounts of epoxy to the mounting blocks on
both ends of the servo tray. Attach the servo tray on
the bottom of the wing with the servo wire harness
notch facing the leading edge of the wing. The
mounting blocks should be attached to the wing
sheeting where the covering was removed in Step
#
14
and not to the wing covering. Allow the epoxy to fully
cure before proceeding to the next step.
Applying the centering tape
❑
20. Starting at the front aileron servo tray block,
apply the 1/2" (12.5mm) white plastic centering tape
completely around the wing over the joint. A small
amount of pressure should be applied to make a
smooth seam.
Checking the hinges
❑
21. The hinge material used in this kit consists of a
3-layer lamination of mylar and polyester. It is
specially made for the purpose of hinging model
airplane control surfaces. Properly installed, this type
of hinge provides the best combination of strength,
durability and ease of installation. The CA hinges in
your plane are preglued and must not be removed.
Check each of the ailerons, the rudder and the
elevator to be sure that they are secure. Gently tug on
each of the control surfaces at each hinge location. If
any of them seem loose, reglue them as described
here. First, flex the surface all the way one direction
(DO NOT REMOVE THE HINGE). Apply a few drops of
thin CA glue onto each hinge. The glue will wick into
the wood providing a strong joint. Use a paper towel
to absorb any excess glue. Wait a few minutes for the
glue to harden, then flex the surface the other
direction and glue the other side of the hinge in the
same manner. Finally, flex back and forth several
times to free up the control surface.
10
Bottom of wing
Centering tape
Servo wire harness notch
If necessary, apply
thin CA to both sides
of the hinge.
Содержание Awarf Series
Страница 1: ...Easy as 1 2 3 V1 3 Copyright 1998 ...
Страница 40: ......