Hobbico Awarf Series, Руководство пользователя

Страница: 17 / 40

Attaching the rudder control horns
❑
22. Locate the nylon control horns on the plastic
parts tree. Position the nylon control horn on the
leading edge and 3/4" (19mm) from the bottom of the
rudder. Mark the two holes with a felt-tip pen. The
control horn will be centered directly over the lower
rudder hinge.
❑
23. The holes of the control horn should line-up
with the gap between the rudder and the vertical
stabilizer.
Mounting the control horns
❑
24. Drill two 1/16" (1.6mm) holes through the balsa
rudder and the lower hinge. Insert both 2 x 20mm
machine screws through the control horn, rudder and
lower hinge into the control horn back plate on the
opposite side of the rudder. Tighten the screws but do
not crush the balsa.
Installing the elevator horn
❑
25. Locate the elevator nylon control horn on the
plastic parts tree. Place the control horn on the
bottom side of the elevator 8-7/8" (225mm) from the
end of the elevator (opposite side of the rudder
control horn) and mark the two holes with a felt-tip
pen. Drill two 1/16" (1.6mm) holes through the
elevator. With two machine screws 2mm x 20mm
attach the control horn .
Locating the rudder exit hole
❑
26. The precut rudder pushrod exit hole is located
on the same side as the rudder control horn, under
the covering, 2" (50.5mm) in front of the rudder on
the top of the fuselage. Locate the exit hole by gently
running your finger down the top of the fuselage.
Removing the covering
❑
27. Using a hobby knife, remove the covering from
the rudder pushrod exit hole. Do not remove the
covering from the exit hole on the opposite side.
Cutting the elevator exit hole
❑
28. The precut elevator pushrod exit hole is located
on the same side of the fuselage as the elevator
control horn, beneath the covering 1/2" (12.5mm) in
front of the horizontal stabilizer. Locate the exit hole
by gently running your finger down the side of the
fuselage over the covering. Using a hobby knife,
remove the covering from the elevator pushrod exit
hole.
Do not remove the covering from the exit hole
on the opposite side of the fuselage.
17
Actual Size
Control Horn
Control Horn
Back Plate (2)
20mm Threaded
Screw (4)
Actual Sizes
Rudder Pushrod Exit Hole