Hobbico Awarf Series, Руководство пользователя

Страница: 23 / 40

Connecting the throttle
❑
5. Slide the throttle control rod into the plastic
guide tube. Insert the stem of the pushrod connector
into the outside hole on the throttle control horn.
Place the retaining clip or ring on the stem and press
on with needle nose pliers.
Engine and control rod installed
Mounting the propeller and spinner
❑
6 Remove the 5.5mm nut and washer from the
drive shaft of the engine. Locate the plastic spinner
and place the backplate of the spinner on the drive
shaft as illustrated in the picture.
N ote : It might be
necessary to enlarge the hole in the spinner backplate
for a proper fit over the engine shaft. Place the washer
and nut back onto the shaft. The propeller must be
seated in the spinner backplate correctly. Tighten the
nut using a 10mm wrench.
Final spinner assembly
❑
7. Place the spinner cone onto the backplate until
they snap together. They must be aligned correctly for
for a proper fit. The spinner cone must not come in
contact with the prop or fatigue and fracture of the
prop may occur over a period of time. Insert both
2 x 12mm self tapping screws into the spinner and
tighten firmly.
23
2 x 12mm S/T
Screw (2)
Actual Size
Spinner cone
Spinner backplate
Pushrod Connector