Assembling the front steering
❑
34. There is a flat area on the stem of the steering
gear for the front wheel. Place the black plastic
nose
gear
control horn on the steering stem with the
steering horn arms next to the coil. Tighten the screw
on the control horn firmly against the flat area on the
stem.
Installing the nose gear
❑
35. Mount a wheel on the nose gear using one
5/32" (4mm) wheel collar. Insert the nose gear stem
into the black plastic nose gear holding bracket on the
fuselage fire wall. Place a 5/32" (4mm) wheel collar
between the plastic bracket and motor mount. Slide
the nose gear stem through the bracket and collar into
the motor mount. Leave a 7/16" (11mm) space
between the control horn and mounting bracket. Lock
the collar by tightening the phillips head screw on the
side of the collar.
Steering pushrod exit hole
❑
36 Using a felt-tip pen, place a mark 5/16" (8mm)
from the engine compartment and 1" (25.5mm) from
the side of the fuselage on the bottom of the fuselage.
Drilling the exit hole
❑
37. Using a 1/8" (3.2mm) bit, drill a hole at a 70
angle into the fuselage. It is important that the plastic
guide tube exit the fuselage at a shallow angle to
prevent binding of the control rod. Leave 3/8"
(9.5mm) protruding through the bottom of the
fuselage. Wick thin CA around the pushrod guide
tube. Trim the tube to a beveled angle flush with the
bottom of the fuselage.
19
Nose Gear Control
Horn(1)
Actual Size
Nose gear bracket
Wheel Collars
Flat area
Содержание Awarf Series
Страница 1: ...Easy as 1 2 3 V1 3 Copyright 1998 ...
Страница 40: ......